In the current environment, humidifiers are still quite popular. Many production workshops and laboratories will see humidifiers in places where humidifiers are needed, such as humidifiers. So what are the matters needing attention in the use and maintenance of humidifiers?

1. Place the humidifier in a ventilated place, and avoid placing it in a dead corner that will cause poor ventilation and fail to achieve the desired dehumidification effect; please do not add additives (such as perfume) produced by informal manufacturers to the water tank, which may cause the water tank and the base to be damaged. Cracks appear in the water part, which affects the normal operation of the machine.

2. The humidifier should also be checked during use. If the float is scaled and the weight increases, it will also lose the water-free automatic stop function, which will affect the normal operation of the humidifier.

3. The humidifier uses pure water to dehumidify, because the water quality in many areas is hard, that is to say, the content of calcium and magnesium ions is high. In addition, some water purifiers such as bleaching powder are used in the water treatment of the water plant. These ingredients are very unfavorable for the humidification of the humidifier. , Some of the calcium and magnesium ions are sprayed out with the water mist and dispersed on the surface of the object and the ground, and form "white powder" scale after drying, and the other part is deposited on the surface of the transducer and the sink to form solid scale, which is all water quality It is caused by impurity, and after the surface of the transducer is fouled, it will affect the humidification effect, and even if it is not cleaned in time, it will cause the load of the transducer and burn out the transducer and the original electronic components.

4. Air duct cleaning, all kinds of humidifiers have air-actuated devices. With this device, they have air inlets and air outlets. Long-term use of the air inlets will also cause dust to block, causing poor air intake and directly affecting water The fog spreads. The air inlet and outlet of the machine should be cleaned regularly.

5. Pay attention to three points when cleaning the transducer: first, disconnect the power supply and operate. Secondly, use a special cleaning agent to remove. When cleaning, 5-10 drops of cleaning fluid should be applied to the surface of the transducer. Of course, it should be increased or decreased according to the degree of scaling until the scale is removed. Note that hard tools can be used to force the descaling. , So as not to scratch the transducer. After: After cleaning, rinse the sink with clean water. When rinsing, do not let water flow into or splash into the inside of the base to avoid short circuit and damage to electronic components.